The Assembly role assembles aerospace parts, subassemblies, and components independently and efficiently.
Duties and Responsibilities:
· Performs assembly tasks with a level of skill.
· Performs daily tasks minimal supervision.
· Installs units, parts, equipment, according to blueprints and specifications, using hand tools and power tools.
· Bolts, screws, or rivets accessories to fasten, support, or hang components and subassemblies.
· Attaches brackets, hinges, or clips to secure installation or to fasten subassemblies.
· Locates and marks reference points and holes for installation of parts and components, using jigs, templates, and measuring instruments.
· Inspects and tests installed units, parts, and equipment for fit, performance, and compliance with standards, using measuring instruments and test equipment.
· Positions and aligns subassemblies in jigs or fixtures, using measuring instruments, following blueprint lines and index points.
· Cuts, trims, and files parts, and verifies fitting tolerances to prepare for installation.
· Installs bushings using liquid nitrogen or presses as required.
· Applies sealants or paint per customer specifications using proper safety devices.
· Uses shop equipment needed to complete operations, such as C-squeeze, arbor presses, ground stud puller, cherry pullers, and shop hand tools.
· Verifies conformance of finished work piece to specifications using standard measuring tools as required.
· Runs parts that meet engineering specifications without supervision.
· Reads and interprets manufacturing drawings at intermediate level.
· Recognizes production problems, informs supervisor, and makes recommendations for improvements or solutions.
· Performs work instructions completely.
· Follows all safety guidelines established by the Company, including proper use of safety equipment and relevant safety procedures.
· Performs other duties as assigned.
· Follows 5-S procedures & works in organized manner. Makes recommendations and takes initiative to improve area.
· Meets job Time Standard without supervision.
· Produces parts with high quality, minimal non-conformances
· Minimum 1-year previous assembly experience in the aerospace industry.
· Basic shop math skills
· Ability to read and follow work instructions.
· G.E.D. or Higher
· Demonstrates a good attitude toward work.
· Reliable - arrives on time to work with good attendance.
· Follows instructions and demonstrates strong attention to detail.
· Communicates well verbally and in writing.
· Mechanically inclined, with good manual dexterity.
· Lifting up to 40 pounds.
· Standing, sitting, and walking throughout the workday.
· Correctable vision that allows employee to perform accurate assembly work
Work may be performed in an office environment or the manufacturing area of the facility which may require use of safety glasses and hearing protection. Exposure to heat, cold, dust, dirt, noise, odors, fumes, vapor from coolant, etc. may also be encountered when in the manufacturing areas to varying degrees.
The assembly environment throughout the workday; this environment may include exposure to noise, dust, fumes, etc. Possible skin and inhaled contact may occur with various sealants, paints, adhesives, liquid nitrogen, Acetone, and chemicals used during assembly or cleaning of parts.
Industry standard safety equipment is provided by the Company, and specific notice is posted in areas where safety equipment is required.
This is a non-management position
This is a full time position
Subscribe to be notified of new jobs