The Dimensional/Layout Inspector / Computerized Measuring Machine (CMM) Programmer Level I carries out the following responsibilities: Run CMM pre-existing programs, create new Part programs, ability to read blue prints, Interprets Geometric Dimensions and Tolerances, and able to inspect product on open setup.

  • Perform visual and dimensional inspection of castings to determine conformance to blue print, or electronic file requirements.
  • Ability to interpret geometrically dimensioned and tolerance engineering drawings.
  • Perform First Article Inspection Reports using AS9102 Forms as required.
  • Work from and with dimensional inspection measurement equipment such as surface plate, sine plates, height gages, radii gages, calipers, micrometers and other assorted hand measurement equipment.
  • To perform the CMM Operator job successfully, an individual must be able to perform each essential responsibility satisfactorily. These requirements are representative, but not all – inclusive, of the knowledge, skill, and ability required of this position. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.
  • Education: High school diploma or general education degree (GED)
  • Experience:  Utilization of both CMM and hand equipment to perform dimensional inspection techniques.
  • Certifications/Licenses:  AFS Laboratory Certification Preferred.
  • Other Required Knowledge, Skills & Abilities:
  •  Computer Skills: Virtual Dimensional Measuring Interface Specification (DMIS) 6.0, Virtual DMIS, Routine CMM Operation, Geometric Dimensioning and Tolerance,
  • Expert PC-DMIS Knowledge required.
  • Polyworks And Bluelight scanning a plus.
  • Software experience; Excel, Word, Power Point, etc.
  • Ability to read blue prints in order to determine and measure features and tolerances.
  • Ability to interpret reduced dimension drawings
  • Ability to program using electronic model
  • Surface Plate Inspection using Standard Inspection Tools
  • Knowledge of Aerospace Standard (AS) 9100 requirements
  • Bilingual – English/Spanish a Plus
Hourly Rate - $24 - $29


This is a non-management position
This is a full time position

Subscribe to be notified of new jobs

Personal Information


Other Information